The Giant 12" x 12" Hoop-It-All comes with a compatible sliding bracket to fit a given embroidery machine. The embroidery arm of the machine must be right of the needle to use the GIANT square Hoop-It-All. It can be removed and attached to any of the four sides of the hoop frame. The bracket is designed with a slot on the underside that attaches to any of the rails located on all four sides of the hoop frame. The bracket is equipped with two or more locking screws to hold the frame in place. A "Support table" is also included.
What the GIANT Hoop-It-All can do: With it's unique sliding bracket, you can combine different embroidery card designs and embroider them anywhere you want on all four sides of the hoop frame. The bracket can be removed and placed on any of the four sides of the hoop's frame and locked in place where desired.
Each embroidery machine is limited to its engineered embroidery field. The GIANT Hoop-It-All allows you to fully utilize the machine's limited embroidery field.
Embroidering in the Center: If the machine's embroidery field is less than 5 inches wide, there will be space in the center that will not be reached by the machine's limited embroidery field, thus making it necessary to re-hoop to fill in the center, if desired.
This can be accomplished by first embroidering the center design using a different hoop, or by placing the center of the fabric just to the right of the Giant Hoop-It-All frame, and then removing it after sewn off. The hole that remains in Hoop-It-All's S-I-A Pressure-Sensitive Adhesive Tear-Away can then be patched with a new piece of the S-I-A and the fabric replaced on the GIANT hoop to complete embroidering all around the four sides.
Monogramming with the GIANT Hoop-It-All: The embroidery field of each machine allows for a limited number of letters to be entered, which requires the removing and re-hooping of the fabric to sew more letters. The GIANT Hoop-It-All allows you to monogram across the entire opening by simply entering the letters allowed, sewing them off, sliding and locking the frame in each new location and continuing until the opening is done.
The Giant Hoop kit includes:
- 1 Giant Hoop
- 1 Sliding bracket (specially designed for each machine)
- 1 Giant Hoop Support Table
- 1 Small roll of SIA Stabilizer (Required)
- Illustrated Instructions
Fits: Baby Lock models Bl60e, Espree 1, Espree 2, Accent EAC, & EM1
Outer Dimensions (W x L): 12" x 12"
Sewing Field (W x L): 10 1/4" x 10 1/4"
Use this product to try these techniques on your project!
(These .pdf files will open in a new window and require Adobe Reader to be viewed. If you do not have Adobe Reader, click here to download the program free.)
California residents: view Proposition 65 warning
California Proposition 65
WARNING
This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Attention California residents: California’s Proposition 65 entitles California consumers to special warnings for products that contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm if those products expose consumers to such chemicals above certain threshold levels. We know you’re concerned about product safety, and Target takes all necessary steps to comply with all applicable safety and health requirements.
On SewingMachinesPlus.com, we provide a Prop 65 link for each item that requires the Prop 65 warning. If a Prop 65 link does not appear in the product info section for the product you wish to purchase, the supplier of the product has indicated that it does not require the Prop 65 warning.