GO! Churn Dash-9 Inch Finished - 55339

Compatible with:

• Go!
• Go! BIG
• Studio

Use the GO! Churn Dash die to make a classic favorite! This block finishes at 9" as the Churn Dash, but feel free to use the building blocks (rectangles, half square triangles, and squares) to make a huge variety of other blocks. This die will be a go-to in your GO! collection.

Features and Benefits:

• Cut so much more in less time—Cut up to 6 layers of 100% cotton fabric at once
• Easiest to use—Simply place die on cutter, then fabric and cutting mat on top
• Get accurate cuts every time—No slipping rulers or mistakes
• Create quilts you never thought you would—AccuQuilt makes cutting curvy classic quilt patterns a snap
• Save fabric with Two Tone Foam—Get more out of your fabric by placing it only over the shape you want to cut
• Safe to use—No blades come anywhere near your fingers
• No more math—Geometric shapes are designed with an accurate 1/4" seam allowance in the design
• Quilt more, clip less—No more clipping all those dog-eared corners
• Quick and easy applique—Apply fusible web to fabric prior to cutting

Die Tips:

• With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors.
• Use cutting mats that matches size of each die.
• For best results, cut with die blades running under roller at an angle. Do not cut with blades parallel to roller.
• Blades on some dies are positioned at an angle. Align fabric to edge of shape, not edge of die board.
• Some dies feature specially designed corners to aid in alignment and pre-cutting.
• For fast applique, apply fusible web to fabrics, then cut shapes with dies.
• Use good quality fabric to reduce fabric stretch.
• It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.

Care & Maintenance:

Use adhesive roller to clean lint and thread from dies. After each use, with the die pick provided with the cutter, remove any threads imbedded between blades and foam. It's normal for threads to get caught where blades meet in a die. Remove with tweezers or die pick. Die blades never need to be sharpened.

Cut Size:

• One 3 1/2"W x 3 1/2"H (8.9 cm x 8.9 cm) square
• Two 2"W x 3 1/2"H (5 cm x 8.9 cm) rectangles
• Two 3 1/2"W x 3 1/2"H (8.9 cm x 8.9 cm) half square triangles with dog-eared corners

California residents: view Proposition 65 warning

×

California Proposition 65

WARNING

This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

Attention California residents: California’s Proposition 65 entitles California consumers to special warnings for products that contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm if those products expose consumers to such chemicals above certain threshold levels. We know you’re concerned about product safety, and Target takes all necessary steps to comply with all applicable safety and health requirements.

On SewingMachinesPlus.com, we provide a Prop 65 link for each item that requires the Prop 65 warning. If a Prop 65 link does not appear in the product info section for the product you wish to purchase, the supplier of the product has indicated that it does not require the Prop 65 warning.

Close